FEATURES
- Nicest pellet flame in the industry!
- 55,000 BTU’s
- Heats up to 2500 sq. ft.
- 79.8% Efficiency
- EPA tested 2.0 g/hr emissions
- Low maintenance burner – This patent pending technology has an agitator rod in the burn pot that breaks up any clinker or ash and helps move it into the ash pan. This greatly reduces cleaning intervals and also allows you to burn lesser quality, inexpensive pellets and alternate fuels.
- Quick start ignitor with air pump
- Quietest pellet stove in the industry – (40 – 45 dB at 10 ft. away)
- Fluted cast iron firebox liner
- Built-in floor protection – no hearth pad required
- Standard wall thermostat
- Tri-mode operating system
- Manual – Hi/Lo – Auto/Off
Retail Locations;
{phocamaps view=map|id=44}
-
Heat Output
-
Ash Level
-
Bag Quality
-
Overall Quality
User Review
( votes)
Comments Rating
( reviews)






42 Responses
Bought a insert m55 and wasted $7000 .From service i recieved from sheerwood industries to over inflated parts .. always a issue
After owning a few other brands, I purchased the M55 and has had less cleaning, more btu (which can cause increases in pellet consumption) but considering is more efficient (BTU output to pounds burnt) than my old brand of stove. Easier to clean with 4 to 5 parts and done. No problems. Very happy
This is my 3rd winter with the M55 FS pellet stove. It heats great but became very noisy a month after purchase. It is a high pitch sound which I believe is cause by the convection blower.
I received very little help from the dealer. I was a bother to them. Not going to go into it. Unfortunately, there is no why to contact Environ. You are stuck with the dealers response. So, I guess I will have to buy a new convection blower ($275) and hope that works. An almost $4000 shame.
Hi. If considering to buy an Enviro m55…Do not. I am writing this now because everyone who buys a stove will encounter at least a few of these problems and need a preemptive warning. We purchased ours 5 years ago and had nothing but trouble since. First year..any setting above 3 a terrible burning smell of burning wires/plastic would emit, even set the fire detector off. Called the dealer, Chimney Restorations in Cambridge MD and a service tech responded. Their answer was you smell the oils burning off, and like a fool I accepted this as an answer. Every time I set the stove at 4 or 5 it would have the same wire/plastic burning smell, could not use any setting above three. Following year the blower went up and cost me close to $340 to fix, still cannot burn the stove at more than 3. Still I continued to complain about the burning smell and they did not care, so I gave up on them. One season after no problems except any heat setting higher than 3 the return of wires/plastic burning smell would revisit and the fire detectors would alarm again. Last year, 2016 the door hinges to the hopper went bad and 200 dollars later I replaced them. Also the scraper to clean the heating exchange tubes warped and will not move. The scraper for the heating exchange tubes also holds the fire wall in place. I have to now shove the firewall in place hoping it will not fall after each cleaning, I have to work a brush into into the tubes to clean the inside part the tubes. The scraper did this job but not anymore. There is not a replacement part for the heating exchange tube scraper and is considered not part part of the heating exchange system. Enviro said to bad, it is not part of the seven year warranty of the heating exchange system, even though there is no replacement parts and there is no possible way to remove it or replace it. Even though I gave up on this dealer where I bought the pellet stove from, I had to talk to them about the scraper and heating exchange tube warranty. This is what the company Enviro said, “I can use the system because it will not affect the stove.” I guess when the lawsuit arises from my the firewall falling onto the fire pot and the home burns down, Enviro will think twice about their answer. This year, 2017 is the worst, circuit board is fried, however, with no lights emitting from the board it still works but cannot go pass two! I will never buy another Enviro product because of its poor quality, and deliberate avoidance of backing their product. I believe this stove should have been replaced immediately after the smell of wires/plastic burning causing the fire detectors to be set off. Also the dealer Chimney Restorations displayed poor service after the stove was sold. I was put to the back burner. I understand others may not have problems but just give it time. DO NOT BUY THIS STOVE.
As I was writing this the heat plate fell and cannot be placed back on..Stove is now a 500lb hunk of metal. I guess its new home is the scrap yard, I literately wasted close to $5000 to buy/install.
I also have the M55 Cast. Love this thing! A little noisy. I have it set on #3 and I burn about 2 bags a day. My house is 4k sqf but I have shut most of it off since the kids are gone. Heats the hous nicley. I have had no issues at all. I clean it out about every 2 days. Very easy.
I have been using O’Malley and TSC Brand pellets and both are so so. Wish I could find better grade pellets. I also heard on here somewhere that by putting the setting on “Muliti Fuels” the stove will burn more efficient. Any ideas?